Honda scooter x8rx power

My optical tuned scooter…

Cargo Carrier W/ramp 36″W – To Load Snow Blowers, Equipment, Power Wheelchairs, and Scooters. Dimensions: 48″ Long X 36″ Wide

• The 48″ long x 36″ wide carrier has a 2″ x 3″ x 3/16″ thick angle frame. The carrier’s expanded metal floor is reinforced with four – 1″ x 1″ square tubing.
• The ramp is surfaced with anti-slip expanded metal and reinforced with seven 1″ wide x 1-1/2″ deep tubing. A wear plate is welded to the bottom of the ramp providing additional reinforcement.
• 2″ square tube (used for attaching to the vehicle) sticks out 8″ from the frame and is received by a class 3 or class 4 trailer hitch.
• Made in the USA – Lightweight all aluminum construction.
• 300 lb. weight capacity (conservative)

Product Description
Aluminum Cargo Carrier with Ramp
Model # 432 ACCTG. Made in the USA

*This listing is for the carrier only. The cost DOES NOT include the snowblower.*

This NEW high quality economical carrier is ideal for transporting heavy equipment. You now have the ability to easily transport equipment or electric wheelchairs/scooters with a Sport Utility Vehicle, or any other vehicle that has a class 3 or class 4 trailer hitch.

What an extremely safe operation when loading onto this low to the ground carrier, as opposed to loading equipment into a high pick-up truck bed, or trying to wrestle the equipment into the back of a SUV (if there is room). With the built-in ramp the operation is fairly simple. The ramp is bolted on and lays in the carrier when not in use. When needed lift the lightweight ramp and deploy it to the ground as it pivots on two bolts. After loading the equipment raise the ramp to an upright position and then hold it in place with a provided hitch pin and already installed bracket. This durable aluminum cargo carrier will not rust or ever need painting.

Please note: anything that goes into a receiver hitch will have a little play. What you can do to eliminate the play (not really necessary though) is to tie down the equipment to the bumper on the inside (side closest to vehicle), and directly to the outside of the carrier at the opposite side (side furthest from the vehicle).
This cargo carrier comes fully assembled except the 2″ square tube needs to be attached (It is detached to drastically reduce shipping charges).

Cargo Carrier W/ramp 36″W – To Load Snow Blowers, Equipment, Power Wheelchairs, and Scooters. Dimensions: 48″ Long X 36″ Wide

COBRA POWER PRO 2-1 EXHAUST PIPE 99-07 YAMAHA ROADSTAR

Product Description

THIS COBRA POWER PRO 2 INTO 1 EXHAUST FITS :

1999-2007
YAMAHA
ROADSTAR
XV1600
XV1700

– Cobra has created what may be the best 2-into-1 pipe ever built. Its beauty comes from an updated traditional design, and it has the kind of modern features no other 2-into-1 pipe has.
– It shines with triple-chromed, full-length header heat shields, and has a unique and stunning collector heat shield so there are no visible welds in this collector area.
– The megaphone uses exclusive technology inside it to eliminate the chances of the muffler ever turning blue.
– On top of that, the PowerPro 2-into-1 produces class-leading horsepower from the moment you install it and roll on the throttle.

COBRA POWER PRO 2-1 EXHAUST PIPE 99-07 YAMAHA ROADSTAR

High power brushless electric scooter

www.jeromedemers.com/blog This is my first test on my electric scooter. I only use a single 14,8V battery on a 18.5V to 37Volts brushless motor! 1480W Outrunner motor ~2HP ratio of 5:5 ( belt drive ) powered by only 14.8V lithium battery ( 16V charged ) The speed was guest to be around 20km/h ( 12.42mph ) Stay tune for the 36V test, already tested but not on youtube. You can find detail information on all the spec. at www.jeromedemers.com/blog